So a mechanic from work recommended the milfuckee 1/4 ratchet and Santa brought one. So I’ve been “working” with it and I’m impressed, I wouldn’t do any 1/2” stuff, easily do most 3/8. It’s small and spin quick for those spot a hex impact don’t like to be in. I’m of the mind that really stuck...
Just spitballing here, but could would cutting reliefs to your material waste, allow the cut to stay cool enough to prevent these issues? I’ve never used a holesaw to cope tube, mainly cause I don’t have the jig to do that and only do small amounts of round tube work. Using a grinder I cut slits...
Come on down. Weather is great, winter is only February. Summer is 7+ months long. The Sonoran desert is one of the most awesome ecosystems on the planet. You can usually go off-road for hundreds of miles before any mud. Cactus doesn’t hurt as bad as ya think, slightly worse. Almost everyone off...
I had to click, I thought oh no I haven’t kept up on futurama, I love bender. Then it hit me as the page loaded, this is about dies for a bender and Bender is ok. Happy Thursday
12mm hex (Allen wrench) for the front diff. I like the kind on a 1/2” socket base.
good practice for going far out is make certain vehicle is In good mechanical order and all it’s juices are at the correct level. Extra oil,atf, gear oil. Check that your spare is in good shape too. Hi lifts are...
The 5fevz with the manual. Jdm motors are usually great. Few swapped parts for USA conversion. More power than 3.slow. Ecu may be only imperial entanglement. Should work though. Best to ya